Standard Hardwire Installation Cable
A Standard Hardwire Installation Cable is included with the TB2, this is suitable for use with the Driver ID Module, which can be added to your order.
Standard CAN bus (ODBII) Installation Cable
For ease of install, a Standard CAN bus (OBDII) installation cable is available for an additional $14 + GST. Note this is NOT suitable for use with the Driver ID Module.
CAN bus (ODBII) + IO Installation Cable
If you would like to use both CAN bus and the Driver ID Module, a CAN Bus (OBDII) + IO Installation Cable is available for an additional $30 + GST.
An IO Cable connects additional telemetry data like sensors, buttons and extra equipment or even control vehicle mechanisms remotely.
Our 700mm OBDII Pass-Through Cable allows two products to be easily simultaneously plugged into the OBDII port of your vehicle interacting with your vehicle's CAN bus (the standard in-vehicle network). The OBDII pass-through gives you the ability to connect two products, such as a trackBOX TB2, plus another product such as a diagnostic scan tool.
An additional benefit of an OBDII Pass-Through is visual security, as it may not be as obvious to those inspecting your vehicle with dubious intent to recognise a device is plugged in and active.
Our Panic or Duress Button is simple, yet effective. Used in conjunction with our TRACKbox TB2, if a staff member gets into trouble and presses the dash-mounted Duress Button, help can be dispatched straight away.
Round Mount Hole Diameter: 22mm
Max Mount Panel Thickness: 6mm
This item may require installation. Please contact us to discuss your specific requirements.